The issues to consider when designing lean tube products

WJ-LEAN will introduce to you today what issues need to be considered in the design of lean tube products.

Firstly, the design of the lean tube racking needs to consider its load-bearing capacity, which can be increased by adding support points, connecting pieces, and using two plastic coated pipes in parallel to increase its strength. When designing the structure, confirm that the main load is directly applied to the pipe fittings rather than the effect on the connectors. The maximum horizontal distance is every 600mm (according to the detailed components to design the detailed structure), which can be freely built. The building block assembly method is adopted, and there must be vertical columns supporting the ground, and every 1200mm, the vertical columns should directly reach the ground. A whole plastic covering pipe has stronger strength than several plastic covering pipes connected in series by clamps. Therefore, when selecting plastic covering pipes, the stressed rod needs to be the entire one, and the connecting rod can be segmented.

The width (center distance) of each column of the turnover shelf is the width of the placed turnover box +60mm; The height of each layer is the height of the turnover box placed +50mm. The determination of the inclination angle of the slide is usually 5-8 degrees. When placing carefully packed materials, heavy materials, and the bottom of the turnover box is relatively smooth, the inclination angle should be smaller.